♠ Practice (Ring) ♠
1. Make a cylinder. (*16sides)
2. Extrude two times and scale it until you are satisfied with it.
3. Use 'Cut' to cut more lines (image above).
4. Select the polygon above and delete it.
5. Use 'Cap'.
6. Select these vertex and move down a bit.
7. Select the bottom edges and click 'Connect'.
8. Use 'Cut' to cut more lines. (Image above)
9. Select the area above and delete it. Then, click 'Cap'.
10. Repeat this steps for another four.
11. Select these two vertex, click 'Collapse'.
12. Repeat this steps for the other vertex at interval.
No comments:
Post a Comment